Onkyo TX-NR1030 Advanced Manual page 53

"BD/DVD" and playing starts.
r Playing may not start depending on the start-up time
of the player. In that case, press
controller.
MY TV: The power of the TV, the player programmed to
CBL/SAT, and the unit is turned on. The input is switched to
"CBL/SAT".
MY MUSIC: The power of the player programmed to TV/CD
and the unit is turned on. The input is switched to "TV/CD"
and playing starts.
r To use another ACTIVITIES button after pressing an
ACTIVITIES button, press ALL OFF and then press the
desired ACTIVITIES button.
To turn off all the devices programmed to the
ACTIVITIES button: Press ALL OFF. The player, the unit
and the TV programmed to the ACTIVITIES button you
pressed before pressing ALL OFF will turn off (or enter
standby).
ALL OFF
r If it is MY MUSIC that you pressed before pressing ALL
OFF, the TV will turn off (or enter standby).
r Some TVs may not turn off (or enter standby).
To change the player programmed to the ACTIVITIES
button: While holding down the REMOTE MODE button
on the remote to which you programmed the desired player, press and
hold the desired ACTIVITIES button about 3 seconds. The
change is complete when the ACTIVITIES button flashes
twice.
To reset the ACTIVITIES button: While holding down
HOME, press and hold ALL OFF about 3 seconds until the
ALL OFF button stays lit. Release HOME and ALL OFF and
then press ALL OFF again. Reset is complete when the
ALL OFF button flashes twice.
Operating Other Components with the Remote Controller
ALL OFF MY MOVIE MY TV MY MUSIC
REMOTE MODE / INPUT SELECTOR
BD/DVD CBL / SAT STB / DVR GAME
P C AUX TV/CD PHONO
TUNER NET USB
REMOTE MODE
T V
ALL OFF
HOME
„ Assigning the desired operation to an
ACTIVITIES button
You can assign an operation sequence to the desired
ACTIVITIES button. For example, if you play the CD player
connected to the unit using the remote controller, the
following button operations are normally necessary.
1. Press RECEIVER to turn the remote controller into
the RECEIVER mode.
2. Press RECEIVER to turn on the unit.
3. Press TV/CD to switch the unit's input to TV/CD.
4. Press to start playing on the CD player.
If you assign these steps with the procedure below, you can
execute them by simply pressing a button. You can assign
up to 32 steps in one procedure.
1.
While holding down RECEIVER, press the desired
ACTIVITIES button (MY MOVIE, MY TV or MY MUSIC)
about 3 seconds until the ACTIVITIES button (MY
MOVIE, MY TV or MY MUSIC) stays lit.
ALL OFF MY MOVIE MY TV MY MUSIC
REMOTE MODE
RECEIVER
2.
Press the buttons to be used in order of their sequence.
Example: Playing CD
1. Press RECEIVER.
2. Press TV/CD.
3. Press .
53