Onkyo TX-NR1030 Advanced Manual page 45

Setting Item Default Value
HDMI Through Off
r When "HDMI Through" is used, the power consumption increases even when the unit is on standby.
However, the increase in power consumption is kept to a minimum by automatically entering the
HYBRID STANDBY mode, where only the essential circuit is operating.
Network
Make the network setting.
r When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the
setting automatically. ("Enable" is set by default) To assign fixed IP addresses to each
components, you must set "DHCP" to "Disable" and assign an address to this unit in
"IP Address" as well as set information related to your LAN, such as Subnet Mask and
Gateway.
Setting Item Default Value
Network Standby Off
Wi-Fi Off(Wired)
Wi-Fi Setup –
Setting Details
Enable or disable "Auto Standby" while "HDMI
Through" is on.
"On": The setting will be enabled.
"Off": The setting will be disabled.
r "HDMI Through" cannot be set to "On" if
"Auto Standby" is set to "Off".
Setting Details
You can turn on the power of the unit via
network using an application such as Onkyo
Remote.
"On": Use this function
"Off": Do not use this function
r When "Network Standby" is used, the power
consumption increases even when the unit
is on standby. However, the increase in
power consumption is kept to a minimum
by automatically entering the HYBRID
STANDBY mode, where only the essential
circuit is operating.
Connect the unit to network via wireless LAN
router.
"On": Wireless LAN connection
"Off(Wired)": Wired LAN connection
You can configure wireless LAN settings by
pressing ENTER when "Start" is displayed.
Setting Item Default Value
Wi-Fi Status –
MAC Address –
DHCP Enable
IP Address –
Subnet Mask –
Gateway –
DNS Server –
Proxy URL –
Proxy Port –
Network Check –
r Wait for a while if "Network" cannot be selected. It will appear when the network function is started up.
Bluetooth
Setting Item Default Value
Bluetooth On
Advanced Settings
Setting Details
The information of the connected access point
will be displayed.
"SSID": SSID of the connected access point.
"Security": Security method of the connected
access point.
"Signal": Signal strength of the connected
access point.
"Status": Status of the connected access point.
This is the MAC address of the AV receiver.
This value is specific to the component and
cannot be changed.
"Enable": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
r If selecting "Disable", you must set "IP
Address", "Subnet Mask", "Gateway", and
"DNS Server" manually.
Displays/Sets the IP address.
Displays/Sets the subnet mask.
Displays/Sets the gateway address.
Displays/Sets the primary DNS server
(primary).
Displays/Sets the proxy server URL.
Displays/Sets the proxy server port number
when you enter "Proxy URL".
You can check the network connection.
Press ENTER when "Start" is displayed.
Setting Details
Select whether or not to use the Bluetooth
function.
"On": Enables connection with a Bluetooth-
enabled device by using the Bluetooth function.
Select "On" also when making various Bluetooth
settings.
"Off": When not using the Bluetooth function
45