Solid-State Drive (M.2) - HP zbook 15 G3 Maintenance And Service Manual

Solid-state drive (M.2)

Description
512-GB, M.2, PCIe
256-GB, M.2, PCIe
128-GB, M.2, PCIe
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.5 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Bottom cover on page
Battery on page 31).
29).
Component replacement procedures
Spare part number
813138-001
795955-001
813137-001
39