Print Position Commands - Epson U590P Information Manual

CONFIDENTIAL
ESC c 3 n selects whether to output paper-end signals or not to a parallel interface. When the TOF
sensor or the BOF sensor is enabled and a paper-end is deleted, the paper-end signal is output. The
default setting is (n=0).
When both of these sensors are selected to output signals and either one detects a paper-end, the
paper-end signal is output. If both of these sensors are disabled, the paper-end signal is not output
(always paper present status). This command is enabled only with a parallel interface and is ignored
with a serial interface.
The paper sensor(s) used to output paper-end signals are selected by using n as follows:
Bit Off/On
0-3 —
Off
4
On
Off
5
On
6-7 —
PRINT #1, CHR$(&H1B);"c3";CHR$(16); ←

Print Position Commands

The TM-U590/U590P supports the following commands for setting the print position:
Command
ESC $
ESC \
ESC a
HT
ESC D
GS L
GS W
Rev. A
Hex Decimal Function
— — Undefined.
00 0 TOF sensor disabled.
10 16 TOF sensor enabled.
00 0 BOF sensor disabled.
20 32 BOF sensor enabled
— — Undefined.
Program Example
Name
Set absolute print position
Set relative print position
Select justification
Horizontal tab
Set horizontal tab positions
Set left margin
Set printing area width
TM–U590/U590P Information Manual
Only TOF sensor enabled
Command Descriptions 1-21