Mitsubishi Electric apricot ls/vs550 Owner's Handbook Manual page 29

E x p a n s i o n
3/6 LS/VS550 OWNER'S HANDBOOK
7. Position the expansion card alongside the slot in which you
wish to install it. Align the rear of the card with the slot in the
rear of the system unit, and, if the card is full length, align the
front of the card with the card guide.
8. Slide the card into the slot ensuring that the card edge
connector engages correctly with the socket on the riser board.
Do not use excessive force.
9. Secure the card by replacing all the screws/clamps that you
removed in Step 5.
10. Connect any necessary signal cables to the card.
11. Check to ensure no other cables or connectors have become
dislodged and replace the system unit cover.
Before you switch on, read the manuals supplied with the card. If
you are certain all is correct, switch on. Your first task if you have
just fitted an ISA card will be to enter the BIOS to register the
settings. Refer to the BIOS chapter for full information. PCI cards
and full 'Plug and Play' cards, should fully configure with the
system software automatically.
Follow any other installation requirements, such as the card's own
configuration or installation software.