Installation Of A Second Hdd - Mitsubishi Electric apricot ls/vs550 Owner's Handbook Manual

S y s t e m D r i v e s
system BIOS is capable of handling this. If the SCSI interface is used
the computer may have several devices connected to the same
interface, each one requiring its own individual 'ID' to be set.
Installing and setting up a second hard drive is not difficult, but if you
do not feel confident about installing a second hard drive you may wish
to have your supplier or an authorised engineer complete this task.
Installation of second HDD
Switch off the system and remove the cover. Take care to observe
anti-static precautions at all times while the system cover is
removed. Information on suitable precautions can be found at the
rear of this manual.
Remove the floppy drive assembly by loosening its screws, sliding it
towards the rear of the system and lifting it out. It may be necessary
to temporarily disconnect drive cables. Take careful note of how
they are fitted.
3
2
1
4 5
1 Floppy drive fixing screws 2-5 CD-ROM assembly screws
Locate and loosen the four screws that hold the CD-ROM drive
assembly into the system, slide it back and lift it out. You now have
access to the hard disk drive assembly. Loosen the screws holding it
to the baseplate and lift carefully out.
LS/VS550 OWNER'S HANDBOOK 2/7