Rds Reception - Kruger&Matz KM1598 Owner's Manual

Owner's manual
• Auto Tuning
Press and hold the
until a station is found.
• Manual Tuning
Repeatedly press the
station you want.
• Preset Tuning (Available only after the stations are preset)
Repeatedly press the PRESET
to select the desired preset number. Its band and frequency are displayed on
the front panel.
Program radio stations
• Automatically
Press and hold the PROGRAM button on the remote control for 2 second or
more to activate automatic program mode. [SCANING] is displayed.
The unit stores all the FM radio stations automatically and then broadcasts the
first preset radio station.
• Manually
1. Tune to the desired station:
2. Press the PROGRAM button on the remote control to activate program mode.
3. Press the PRESET
select the preset number.
Note: If you select more than 20, the preset number will be changed to "1"
automatically.
4. Press the PROGRAM button again to store the station.
5. Repeat above steps 1-4 for each station you want to store in memory with
a preset number.
Note: If the unit is unplugged or if a power failure occurs, the preset stations will
not be erased after being stored.

RDS RECEPTION

FM Display Modes
Every time you press the DISPLAY button, the display will cycle through the following
display modes: Station Name, Programme Type, Time, Radio Text, Frequency
(looped). The information is displayed on the lower segment of the display.
CD OPERATION
CD Playing
1. Rotate the SOURCE knob on the unit or press the CD/USB button on the
/ button, the frequency changes down or up automatically
/ buttons to change the frequency until you find the
/ (UP/DOWN) buttons on the remote control
/ (UP/DOWN) buttons on the remote control to
33