Preset Tuning; Program Radio Stations Automatically; Presetting Stations; To Change The Fm Reception Mode - Kruger&Matz KM1584CD Owner's Manual

Owner's manual
• Preset Tuning (Available only after the stations are preset)
Repeatedly press the
preset number. Its band and frequency are displayed on the front panel.

Program radio stations automatically

Note: You can program a maximum of 20 preset radio stations.
In tuner mode, press and hold PROGRAM button to activate automatic. [AUTO] is displayed.
The unit stores all the FM radio stations automatically and then broadcasts the first preset radio
station.

Presetting Stations

You can manually preset up to 20 FM stations.
To tune in to the desired station:
1. Press the PROGRAM button on the remote control, the preset number will be displayed.
2. Press the PRESET (UP/DOWN) buttons on the remote control, or press the
on unit panel to select the preset number.
Note: If you select more than 20, the preset number will be changed to "1" automatically.
3. Press the PROGRAM button again to store the station. The display will return to the
broadcast frequency display.
4. Repeat above steps 1 to 3 for each station you want to store in memory with a preset
number.
Note: If the unit is unplugged or if a power failure occurs, the preset stations will not be erased after
being stored.

To change the FM Reception Mode

Press the Mode button to select the Stereo or Mono channel to receive the best FM reception mode.

FM Display Modes

Every time you press the DISPLAY button, the display will cycle through the following display
modes: Station Name, Programme Type, Time, Radio Text, Frequency (looped). The information is
displayed on the lower segment of the display.
Station Name
When an RDS station is received, the name of that station will be displayed.
Programme Type
Programme type identification signal. (Example: News, Rock, Classical music.)
Time
The RDS CLOCK system may not properly operate in areas where RDS CLOCK service is
not available. Once RDS CLOCK service is available, the RDS CLOCK system will commence
operation.
Radio Text
This displays a station description.
Frequency
This shows the frequency of the current station, e.g. 89.80 MHz.

CD OPeRATION

CD Playing
1. Rotate the SOURCe button on the unit or press the CD button on the remote control. The word
"DISC" will be displayed on the front panel.
2. Press the button to open the disc door and place the disc on the disc tray (with the printed
side up).
/
button on the remote control or on the unit to select the desired
/ button
33