Table of Contents
Advertisement
Add Bandwidth Management Group Rules
Click on [Add] tab. You will see the following screen.
Configure [Add SBM] Settings following the instructions below.
Sequence Number
Rule Name
Rule Enable
Internal IP
Protocol
Service Port Range
External Interface
Bandwidth Allocation
Ratio
Utilize Bandwidth More
than Guaranteed
This defines the sequence of the SBM rules. If a packet fits the conditions set
by the SBM rules, the packet will then be sorted according to the first SBM rule
from the top of the list.
Name of the SBM rule.
Enable/Disable this SBM rule
Set up the internal IP for this SBM rule.
Set up the protocol (TCP or UDP) for the ACL to be enabled.
Set up the Service Port Range (e.g., HTTP is TCP/80) for the SBM to be
enabled.
Choice the interface for this SBM rule, WAN 1/ WAN2.
By Ratio, by Bandwidth or by pre-defined Group rules
The ratios of the whole upload bandwidth according to the External Interface.
Check this box if you wish to allow the traffic confirming this SBM rule to be
able to utilize the whole bandwidth when the bandwidth is idle.
48
Advertisement
Table of Contents
