Planet vrt-420n User Manual page 11

3. Connect all of your network devices to LAN port of VRT-420N. Connect all your computers,
network devices (network-enabled consumer devices other than computers, like game console, or
switch / hub).Connect one of the LAN ports on VRT-420N to your LAN switch/hub or a computer with a
RJ-45 cable.
4. Plug in power adapter and connect to power source. After power on, VRT-420N will start to
operate.
5. Please check all LEDs on the front panel. 'Status' LED should be steadily on. WAN and LAN
LEDs should be on if the computer / network device connected to the respective port of the router is
powered on and correctly connected. If PWD LED is not on, or any LED you expected is not on, please
recheck the cabling, or jump to 'Troubleshooting' for possible reasons and solution.
Note:
1. ONLY use the power adapter supplied with the VRT-420N. Otherwise, the product may be
damaged.
2. If you want to reset VRT-420N to default settings, press and hold the WLAN ON/OFF + USB
Eject button over 30 seconds and release. And then wait for VRT-420N restart.
11