Adjusting The Motion Control Neutral Lock Pivot; Hydraulic System Maintenance; Servicing The Hydraulic System - Toro Z Master Commercial 2000 74141TE Operator's Manual

Figure 63
RH Motion Control Shown
1. Torque the lock nut to 200 in-lb (16.7 ft-lb). Bolt must
protrude past end of locknut after torque.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Adjusting the Motion Control
Neutral Lock Pivot
The flanged nut can be adjusted to obtain a more desired
motion control lever resistance when moving it to the neutral
lock position. See Figure 64 for adjustment options.
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired feel.
For more resistance, tighten the flanged nut.
For less resistance, loosen the flanged nut
3. Tighten jam nut.
Figure 64
1. Flanged nut 2. Jam nut
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Hydraulic Oil Type: Toro
or Mobil ® 1 15W-50.
Important: Use oil specified. Other fluids could cause
system damage.
Checking the Hydraulic Oil Level
Service Interval: Every 25 hours
1. Allow the hydraulic oil to cool down. Check the oil
level when the oil is cold.
2. Check expansion reservoir and if necessary add Toro
HYPR-OIL ™ 500 hydraulic oil to the FULL COLD
line.
1. Expansion reservoir
44
® HYPR-OIL ™ 500 hydraulic oil
G017452
1
2
G017451
Figure 65
2. FULL COLD line
®