Controls System Maintenance; Adjusting The Control Handle Position - Toro Z Master Commercial 2000 74141TE Operator's Manual

2
1
6
Figure 59
1. Idler pulley
2. Idler spring post
3. Engine pulley
9. Install the clutch stop shown in Figure 58.
10. Install the mower belt. Refer to Replacing the Mower
Belt.
3
4
5
g017437
4. Pump drive belt
5. Right hand hydraulic pump
pulley
6. Left hand hydraulic pump
pulley
Controls System
Maintenance
Adjusting the Control Handle
Position
There are two height positions for the control levers; high and
low. Remove the bolts to adjust the height for the operator.
1. Disengage the PTO, move the motion control levers to
the neutral locked position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the bolts and flange nuts installed in the levers
(Figure 60).
4. Align the levers front to rear position by bring the
levers together to the neutral position and slide them
until they are aligned, then tighten the bolts (Figure 61).
1. Bolt
2. Handle
42
Figure 60
3. Control lever
4. Nut