Step 3: Checking The Installation - NETGEAR GS700AT Series Hardware Installation Manual
Smart switch with gigabit ports
Hide thumbs
Also See for GS700AT Series:
- Administration manual (4 pages) ,
- Software administration manual (4 pages) ,
- Hardware installation manual (38 pages)
Table of Contents
Advertisement
5. Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack.
Figure 2-1
Note: Always install devices from the bottom of the to the top. This will prevent the rack
from over balancing and toppling over.
Step 3: Checking the Installation
Before applying power perform the following:
•
Inspect the equipment thoroughly.
•
Verify that all cables are installed correctly.
•
Check cable routing to make sure cables are not damaged or creating a safety hazard.
•
Ensure all equipment is mounted properly and securely.
Installation
GS700AT Hardware Installation Guide
v1.0, October 2008
2-3
Advertisement
Table of Contents
Troubleshooting
