Step 6: Applying Ac Power - NETGEAR GS700AT Series Hardware Installation Manual

To install an SFP GBIC module:
1. Insert the SFP module into the SFP module bay.
2. Press firmly to ensure the module seats into the connector.
Figure 2-3

Step 6: Applying AC Power

NETGEAR Smart Switch does not have an ON/OFF switch. The method of applying or removing
AC power is by connecting or disconnecting the power cord. Before connecting the power cord,
select a grounded 3-pronged AC source that is not controlled by a wall switch, which can turn off
power to the switch. After selecting an appropriate AC source, use the following procedure to
apply AC power.
1. Connect the female end of the supplied AC power adapter cable to the power receptacle on the
back of the switch.
2. Connect the 3-pronged end of the AC power adapter cable to the 3-pronged AC source.
When applying power, the Power LED on the switch's front panel is green.
If the Power LED does light up, check that the power cable is plugged in correctly and that the
power source is functioning correctly. If this does not resolve the problem, refer to Appendix A -
"Troubleshooting".
Installation
GS700AT Hardware Installation Guide
v1.0, October 2008
2-5