Transportation - Bosch WVH28441AU Instruction Manual And Installation Instructions

Plug into the mains.
1.
Turn the tap on.
2.
Switch on the appliance.
3.
Close the door. Do not load any
4.
laundry.
Select the
5.
Fluff Clean
programme.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
7.
dispenser .
II
Add standard detergent to
8.
dispenser according
II
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
9.
Select /Reload
10.
Start
When the programme ends, switch
11.
off the appliance.
Your washer dryer is now ready for use.

Transportation

Preparatory work
Turn off the tap.
1.
Release the water pressure in the
2.
supply hose.
Filter in the water inlet hose blocked
~ Page 29
Drain any residual washing water.
3.
Drain pump blocked ~ Page 28
Disconnect the washer dryer from
4.
the power supply.
Remove the hoses.
5.
Installing transportation protection
devices:
Remove the covers and keep in a
1.
safe place.
If required, use a screwdriver.
40°C
l
.
A
Installation and connection
Insert all 4 sleeves.
2.
Clamp the mains cable on the
holders. Insert and tighten the bolts.
Before switching on the appliance:
Notes
remove the transportation
Always
■
protection devices!
To prevent unused detergent from
■
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser and start the
II
[ programme.
Drain
en
or
Spin 0
43