Bosch WVH28441AU Instruction Manual And Installation Instructions page 33

Faults
Display panel/indicator
lights do not function
while the appliance is run-
ning.
The programme duration
changes during the wash
cycle.
Detergent residue on the
washing.
Spin noise during the dry-
ing phase.
Different coloured fluff
from the previous drying
cycle is deposited on the
laundry during the subse-
quent wash cycle.
Water inlet noise during
the drying phase, the tap
symbol flashes during the
drying phase.
Drying duration extended.
Drying programme does
not start.
Cause/Remedy
Power failure?
■
Fuse tripped? Switch on/replace fuse.
■
If the fault occurs repeatedly, call customer service. ~ Page 35
■
Not a fault – unbalanced load detection system adjusts imbalance.
■
Not a fault – foam detection function active. Additional rinse cycle.
■
Occasionally phosphate-free detergents contain water-insoluble residue.
■
Select Rinse à or brush items when the laundry is dry.
■
This is an innovative process known as thermal spinning used to reduce
energy consumption during the drying phase.
Run the Fluff Clean l Ž (cold) programme without laundry to remove fluff
which has collected in the washer drum during the drying phase.
The washer dryer runs a self-cleaning cycle to remove fluff which was depos-
ited by the laundry during the drying phase. This requires a little water. There-
fore, the tap must be turned on even during the drying phase.
According to the air cooling principle, a higher ambient temperature will
■
result in poor drying performance, so the drying time will be extended.
Ensure good ventilation to allow surplus heat to escape.
Air filter blocked? Clean the air filter ~ Page 30
■
Run the Fluff Clean l Ž (cold) programme to remove fluff which has col-
■
lected in the washer drum during the drying phase.
Drying programme not selected? Overview of programmes~ Page 20
■
Door not closed properly?
■
Pump blocked? Clean the drain pump.~ Page 28
■
Faults and what to do about them
en
33