NETGEAR FS102 Installation Manual page 5

LEDs
This table describes the activity of the Model FS102/FS104/FS108 switch LEDs.
Label Color Activity
Pwr (Power) Green On
Off
Rx/Tx/Collision Green Blinking
Yellow Blinking
100 Mbps Green On
Off
Link Green On
(located at the
top left corner Off
of each vista
10BASE-T port)
FDX Green On
(located at the
top right corner Off
of each vista
10BASE-T port)
Model FS102, Model FS104, Model FS108 Fast Ethernt Switch Installation Guide
Description
Power is supplied to the switch.
Power is disconnected.
Packet transmission or reception is occurring on the port.
Data collisions are occurring on the port. The blinking action
corresponds to the number of collisions. When a collision
occurs, the connected device pauses and transmits again
after waiting a specified time. Note that occasional collisions
are normal.
The port is operating at 100 Mbps.
The port is operating at 10 Mbps.
A valid link is established on the port.
A link is not established on the port.
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.