Prepare The Site; Install The Switch; Connect Devices To The Switch - NETGEAR FS102 Installation Manual

Fast ethernet switch
Table of Contents

Advertisement

Prepare the Site

Before you begin installing your switch, prepare the installation site. Make sure your operating
environment meets the operating environment requirements of the equipment.
Characteristic
Requirement
Temperature
Ambient temperature between 0
No nearby heat sources such as direct sunlight, warm air exhausts, or
heaters.
Operating humidity
Maximum relative humidity of 90%, noncondensing.
Ventilation
Minimum 2 inches (5.08 cm) on all sides for cooling.
Adequate airflow in room or wiring closet.
Operating conditions
At least 6 feet (1.83 m) to nearest source of electromagnetic noise (such
as photocopy machine or arc welder).
Power
Adequate power source within 6 feet (1.83 m).

Install the Switch

To install your switch on a flat surface, you do not need any special tools. Be sure the switch is
positioned with at least 2 inches of space on all sides for ventilation.
To install the switch on a wall, measure the distance between the mounting holes on the back of
the switch and mark the wall to match the location of the mounting holes on the switch. At the
marks, screw into the wall the two screws in the mounting kit included in your package contents.
Choose a location that is near the devices to be connected, is close to an electrical outlet, and
provides at least 2 inches of space all around the switch for ventilation.

Connect Devices to the Switch

Before connecting the switch, be sure you review "Applications" for to determine the appropriate
configuration for your networking needs.
To connect the switch:
1.
Connect the devices to the 10/100 Mbps ports on the switch, using Category 5 UTP
cable and an RJ-45 plug.
Note: Ethernet specifications limit the cable length between your PC or server and the
switch to 328 feet (100 meters).
2.
Set the Normal/Uplink push button.
The Normal/Uplink push button eliminates the need to use a crossover twisted pair cable for
daisy-chaining or cascading. Use the following guidelines to configure port 1 and port 2 on
the Model FS102 switch, port 4 on the Model FS104 switch, or port 8 on the Model FS108
switch for uplink or normal wiring:
Configure the port for normal wiring if the port is to be connected to an uplink-wired
device, such as a network station or a PC.
Configure the port for uplink wiring if the port is to be connected to a normal-wired
device, such as a 100 Mbps hub or another switch.
The remaining (normal) ports on the switch cannot be configured for uplink wiring. If you are
using one of these ports to connect to another normal port, you must use a crossover twisted
pair cable to connect the two ports. Refer to "Cable and Connector Information" for
information about crossover twisted pair cable and straight-through twisted pair cable.
Model FS102, Model FS104, Model FS108 Fast Ethernt Switch Installation Guide
G
G
G
G
and 40
C (32
and 104
F).

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fs104Fs108

Table of Contents