Installing The Switch; Installing The Switch On A Flat Surface; Installing The Switch In A Rack - NETGEAR FS 517TS User Manual

Installing the Switch

You can install the NETGEAR FS517TS and FS524S Switches on a flat surface or in
a standard 19-inch rack.

Installing the Switch on a Flat Surface

1. The switch ships with four self-adhesive rubber footpads. Stick one rubber foot pad
on each of the four concave spaces on the bottom of the switch. The rubber foot pads
cushion the switch against shock/vibrations. They also provide space between each
stacked switch for ventilation.
2. To stack switches:
• Repeat step 1 for each switch to be stacked.
• Place the first switch on a firm flat surface where you want to install the stack.
Stack the other switches on top of this unit.
• Proceed to "Connecting Switches to the Stack's Backplane" on page 21.

Installing the Switch in a Rack

To install the FS517TS or FS524S Switch in a rack, use the following procedure (and
refer to Figure 4-1). To perform this procedure, you need the 19-inch rack-mount kit
supplied with your switch.
1.Attach the supplied mounting brackets to the side of the switch.
2.Insert the screws provided in the rack-mount kit through each bracket and into the
bracket mounting holes in the switch.
3. Tighten the screws with a #1 Phillips screwdriver to secure each bracket.
4. Align the mounting holes in the brackets with the holes in the rack, and insert two
pan-head screws with nylon washers through each bracket and into the rack.
installation 4-3