Table of Contents
Advertisement
Pressure jet oil burner installation
The Unit pressure jet oil burner installation
instructions are included in the burner
packaging.
Only use bolts when securing
the burner to the boiler flange,
whose thread penetrates the
boiler flange by a maximum of
15 mm. Only use pressure jet
gas burners compliant with EC
Directive 90/396/EEC.
Electrical supply
Do not route sensor leads with
Note
230 V mains cables.
Connect the heating circuit pump(s) and
the DHW cylinder loading pump(s) on-site
via contactor, if:
• The burner and pump draw more than
2 A each.
• The total control unit power consumption
is exceeded.
Observe the control unit installation and
operating instructions.
3060918_1203
Pressure jet oil burner installation /
Electrical supply
Boiler flange
Burner plug wiring diagram
Electrical supply
Burner flange holes
1
N T1 T2 S3 B4
BS
Cable grommets
MV
25
Hide quick links:
Advertisement
Table of Contents
