Inspection And Confirmation After Reassembly - Hitachi NR 65AK Service Manual

11. INSPECTION AND CONFIRMATION AFTER REASSEMBLY

Check that Plunger (A) [47] moves smoothly.
Check that there is no air leakage from each part.
While driving nails with an air pressure of 4.5 kgf/cm 2 (63 psi), check that there is no misfiring and bending of
nails.
Recheck the tightening torque of each screw.
Check that Pushing Lever (A) [30] slides smoothly.
Check that the machine will not operate only by pulling the Trigger [52]. Also check that the machine will not
operate only by depressing Pushing Lever (A) [30].
--- 36 ---