Viewing The Log File; Viewing Parameters; Maintenance - Security-Center TV7203 Installation Instructions Manual

Viewing the log file

Click this link on the configuration page to display the system log file. The contents of the file supply useful
information about the configuration and the connection following a system start. The standard of the log file
is RFC 3164. You can also send data to a log server. Enable "Remote Protocol" and enter the IP address
and the port number of the server.

Viewing parameters

Click this link on the configuration page to display all system parameter sets. The contents correspond to
those of CONFIG.INI.

Maintenance

Reboot system
Click to reboot the system.
Factory default
Click to restore the factory settings. All previous settings are discarded.
Upgrade firmware
Like an update with the installation wizard, you can update the firmware of the network camera here. You
can download the latest firmware from www.security-center.org. Select the update file (flash.bin) and click
"Upgrade". The update takes a short time. When you restart the camera, it is started with the new firmware.
35