Wlan Configuration - Security-Center TV7203 Installation Instructions Manual

<URL> http://<Netzwerkkamera>/setup/network.html
<Network Camera> is the domain name or original IP address of the CMOS network camera.

WLAN configuration

"SSID" (Service Set Identifier) The name that identifies the wireless network. The access point and the WLAN
network camera must use the name SSID. The factory setting is "default". IMPORTANT: The max. length is
32 characters; do not use: " , ", <, > and spaces.
"Wireless mode" Select one of the following:
"Infrastructure" The network camera is connected to the network via an access point.
"Ad-Hoc" In this mode, the network camera can communicate direct with another network adapter
(network card). A so-called Peer-to-Peer environment is set up.
"Channel" In infrastructure mode, the channel used is selected automatically by the camera. In Ad-Hoc
mode, the channel must be set manually according to the other network adapter.
"TX rate" Set the maximum transmission speed in the network. In the factory, the speed is set to select
automatically ("auto"), and the camera always tries to reach the highest transmission speed according to the
environment.
"Preamble" A so-called preamble is set before each data packet. This preamble is used to synchronise the
receiver and the sender. With a "short preamble", the synchronisation length is shorter and therefore not so
secure.
25