Procedure - Yamaha 6c Owner's Manual

Maintenance
lowing procedures.
ECM01411
NOTICE
Do not place the outboard motor on its
●
side before the cooling water has
drained from it completely, otherwise
water may enter the cylinder through
the exhaust port and cause engine trou-
ble.
Store the outboard motor in a dry, well-
●
ventilated place, not in direct sunlight.
EMU28303

Procedure

EMU28334
Flushing in a test tank
ECM00300
NOTICE
Do not run the engine without supplying
it with cooling water. Either the engine
water pump will be damaged or the en-
gine will be damaged from overheating.
Before starting the engine, be sure to
supply water to the cooling water passag-
es.
1. Wash the outboard motor body using
fresh water. NOTICE: Do not spray wa-
ter into the air intake.
ther information, see page 41.
2. Disconnect the fuel line from the motor
or shut off the fuel cock, if equipped.
3. Remove the engine top cowling and si-
lencer cover. Remove the propeller.
4. Install the outboard motor on the test
tank. Fill the tank with fresh water to
above the level of the anti-cavitation
plate. NOTICE: If the fresh water level
is below the level of the anti-cavita-
tion plate, or if the water supply is in-
sufficient, engine seizure may occur.
[ECM00291]
39
For fur-
[ECM01840]
1. Water surface
2. Lowest water level
5. Cooling system flushing is essential to
prevent the cooling system from clog-
ging up with salt, sand, or dirt. In addi-
tion, fogging/lubricating of the engine is
mandatory to prevent excessive engine
damage due to rust. Perform the flush-
ing and fogging at the same time.
WARNING! Do not touch or remove
electrical parts when starting or dur-
ing operation. Keep hands, hair, and
clothes away from the flywheel and
other rotating parts while the engine
is running.
[EWM00091]
6. Run the engine at a fast idle for a few
minutes in neutral position.
7. Just prior to turning off the engine, quick-
ly spray "Fogging Oil" alternately into
each carburetor or the fogging hole of
the silencer cover, if equipped. When
properly done, the engine will smoke ex-
cessively and almost stall.
8. Remove the outboard motor from the
test tank.
9. Install the silencer cover/cap of fogging
hole and top cowling.
10. If the "Fogging Oil" is not available, run
the engine at a fast idle until the fuel sys-
tem becomes empty and the engine
1
2
ZMU02051