Checking Wiring And Connectors; Checking Propeller - Yamaha 6c Owner's Manual

parts while the engine is running.
ECM00490
NOTICE
This procedure must be performed while
the outboard motor is in the water. A
flushing attachment or test tank can be
used.
A diagnostic tachometer should be used for
this procedure. Results may vary depending
on whether testing is conducted with the
flushing attachment, in a test tank, or with the
outboard motor in the water.
1. Start the engine and allow it to warm up
fully in neutral until it is running smooth-
ly.
TIP:
Correct idling speed inspection is only possi-
ble if the engine is fully warmed up. If not
warmed up fully, the idle speed will measure
higher than normal. If you have difficulty ver-
ifying the idle speed, or the idle speed re-
quires adjustment, consult a Yamaha dealer
or other qualified mechanic.
2. Verify whether the idle speed is set to
specification. For idle speed specifica-
tions, see page 9.
EMU29112

Checking wiring and connectors

Check that each grounding wire is properly
●
secured.
Check that each connector is engaged se-
●
curely.
EMU32111

Checking propeller

EWM01880
WARNING
You could be seriously injured if the en-
gine accidentally starts when you are
near the propeller.
Before inspecting, removing, or install-
●
ing the propeller, place the shift control
in neutral, turn the main switch to "
(off) and remove the key, and remove
the clip from the engine shut-off switch.
Turn off the battery cut-off switch if
your boat has one.
Do not use your hand to hold the propeller
when loosening or tightening the propeller
nut. Put a wood block between the anti-cavi-
tation plate and the propeller to prevent the
propeller from turning.
Checkpoints
Check each of the propeller blades for
●
Maintenance
ZMU02875
ZMU01897
"
48