Contents - Siemens WT46W570 Installation And Use Manual

Installation Technical data
– Delivery specification: dryer, instructions for installation and use.
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
1. Setting up the dryer Take all accessory parts
out of the drum.
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean, level The drum must be empty.
and solid surface.
– Keep the cooling grille at the front of the dryer
unobstructed.
– Keep the area around the dryer clean.
– Make the dryer level using the threaded feet
and a spirit level.
– Do not unscrew the threaded feet further than 20 mm.
Do not remove the threaded feet under any
circumstances.
Do not set up the dryer behind a door or sliding
door as this may obstruct or prevent the dryer door
from opening. This will prevent a potentially fatal
danger to children from locking themselves in. Clean and level
Make sure that the air
inlet remains unobstructed
Mains connection see safety instructions -> Page 11.
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate (-> Page 9) must correspond.
– The connected load and necessary fuse protection are specified on the rating plate.
Do not operate the dryer if
Frost protection
there is a danger of frost.
Preparation
1. Empty the condensation container -> Page 4.
2. Turn the programme selector to any programme.
Optional accessories
3. Press the inicio/stop (Start/Stop) button -> condensation is pumped into the container.
4. Wait 5 mins., empty the condensation container again.
Order no.:
5. Turn the programme selector to stop (Off).
WZ
Transport
20310
– Preparation of dryer -> see Frost protection.
WZ
– Transport the dryer in a vertical upright position. 20300
– Following transportation, leave the dryer to stand for one hour.
WZ
20290
The dryer contains residual water;
this can flow out if the dryer is tilted.
WZ
8 20460
7
What to do if ...
Dimensions (DxWxH) 60 x 60 x 85 cm (height adjustable)
Repairs must only be carried out by the aftersales service or an authorised expert.
Weight approximately 53 kg Before you contact the after-sales service, please make sure that you are unable to resolve
the problem yourself. You will be charged for advice if a technician is called out, even during
Max. capacity 7 kg
the warranty period. You can find your nearest customer services in the enclosed list. When
Condensation container 4.0 l contacting the after-sales service, please specify the product number (E-Nr.) and production
number (FD) of your appliance (see inside of door).
Connection voltage 220-240 V
The inicio/stop (Start/Stop)
Connected load max. 1000 W
indicator lamp does not light
Fuse protection 10 A up.
Ambient temperature 5 - 35 °C
The symbol and Start/Stop
Product number/ indicator lamp flash.
Inside of door
Production number
The symbol and Start/Stop
indicator lamp flash.
You can find the rating plate on the back of the dryer.
Dryer does not start.
Consumption rates These are guide values determined under standard
conditions.
Spin speed in rpm Drying time** Energy
(residual moisture) in min. consumption**
in kWh Water is leaking out.
resistentes algod.
The door opens by itself.
(Whites/coloureds) 7 kg
The required degree of
Seco para guardar (cupboard dry)* 1400 (approx. 50 %) 112 1.35
dryness was not achieved or
1000 (approx. 60 %) 131 1.60
the drying time was too long.
800 (approx. 70 %) 150 1.86
Seco para (iron dry)* 1400 (approx. 50 %) 80 0.96
1000 (approx. 60 %) 99 1.22
800 (approx. 70 %) 118 1.47
Sintéticos (Easy-care) 3.5 kg
Seco para guardar (cupboard dry)* 800 (approx. 40 %) 51 0.56
600 (approx. 50 %) 63 0.70
*Test program according to DIN EN 61121 Laundry damp.
**The values may differ from the those specified depending on the type of fabric, mixture of
laundry to be dried, residual moisture in the fabric and loading capacity.
Drum interior light (bulb E14, 15 W) The moisture content of the room
The drum is illuminated after the door is opened or closed, and also after the programme is has increased significantly.
started. It goes out automatically. Replacing the bulb -> Page 10.
Cln appears in the display
panel.
Mains failure.
Washer-dryer stack connection set The interior light is not working. Pull out the appliance plug, remove the cover cap in the
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space.
This connection set must always be used to secure the dryer to the washing machine.
Same as WZ 20310, but with pull-out worktop. Other intermittent noises and
vibrations.
Loud humming noise for
Installation underneath the worktop
several seconds.
Risk of electric shock!
If you cannot rectify a fault yourself or a repair is necessary:
Instead of the appliance covering plate, you must have a metal cover fitted by an expert.
– Turn the programme selector to stop (Off).
Platform
– Remove the appliance plug from the socket.
Facilitates loading and unloading the appliance. 9
– Call the after-sales service -> see the after-sales service directory.
The basket contained in the drawer can be used to carry the laundry.
Safety instructions
Emergency – Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the – In rooms inside the house.
dryer...
– To dry fabrics.
The dryer must – Be used for other purposes than those described above.
NEVER...
– Be modified in terms of its technology or attributes.
Dangers – The dryer must not be used by children or persons who have not been
Mains plug plugged in?
instructed in its use.
Programme selected?
– Do not leave children unsupervised near the dryer.
Check the socket fuse.
– Keep pets away from the dryer.
Empty the condensation container.
– Remove all objects from pockets.
Clean the condensation container filter if necessary ->Page 6.
Make especially sure that cigarette lighters are removed as they constitute an
Clean the fluff filter -> Page 4.
-> explosion hazard.
– Do not lean or sit on the door -> risk of tipping.
inicio/stop (Start/Stop) button selected?
Installation – Secure loose cables -> tripping hazard.
Door closed?
– Do not operate the dryer if there is a risk of frost.
Programme set?
Mains – Connect the dryer according to specifications to an AC earthed socket, as
Ambient temperature greater than 5 °C? connection otherwise it cannot be guaranteed that the appliance is completely safe.
Make sure the dryer is level. – The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
Push the door closed until you hear it engage.
– The appliance plug and socket must be compatible.
Clean the fluff filter -> Page 4.
– Do not use multiple plugs/couplings and/or extension cables.
Empty condensation container -> Page 4. – Do not hold the appliance plug with wet hands -> risk of electric shock.
Ambient temperature higher than 35 °C -> airing.
– Never pull the appliance plug out of the socket by its cable.
Air inlet may be blocked -> keep unobstructed.
– Do not damage the mains lead -> risk of electric shock.
Was an unsuitable programme selected? -> Page 7.
Operation – Only load the drum with laundry.
Laundry too dry? The laundry in a dryer with a heat
Check the contents before you switch the dryer on.
exchanger requires sufficient residual moisture.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
Has the dryer been installed with sufficient space on all
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
sides? Ensure that air can circulate.
cleaning solvent, etc.) -> fire/explosion hazard.
Mains failure -> Restart the dryer.
– Dust (e.g. coal dust, flour) poses a danger: do not use the dryer
Fine layer of scale on the moisture sensors -> Clean the ->explosion hazard.
moisture sensors -> page 6.
– Do not put laundry containing foamed material/rubber in the dryer -> elastic
Use the next drying programme up or use the timer material may be destroyed and the dryer may be damaged due to possible
programme as a supplement -> Page 7. deformation of the foamed material.
Warm laundry feels damper than it really is! – Switch off the dryer once the programme has ended.
Make sure the room is sufficiently ventilated. – Condensation is not drinking water and may be contaminated with fluff.
Air inlet blocked? -> keep unobstructed. Defect – Do not use the dryer if it is defective or if you suspect it is.
Repairs must only be carried out by the after-sales service.
Not an error! Automatic cleaning of heat exchanger.
– Do not use the dryer if the mains cable is defective. To avoid danger, only
Do not empty the condensation container.
have the defective mains cable replaced by the after-sales service.
Remove laundry from the dryer immediately and spread out.
– Always pull the mains plug out of the socket before changing the bulb for the
This allows the heat to dissipate.
interior light -> risk of electric shock.
Spare parts – Only use genuine spare parts and accessories for safety reasons.
interior above the door (use Torx 20 screw driver) and
– Dryer: pull out the appliance plug, then cut off the mains cable from the
Disposal
replace the bulb. Close the cover cap.
appliance.
Never operate the dryer without a cover cap.
Dispose of at municipal waste disposal facility.
Not an error!
– Packaging: do not leave children alone with packing parts
Automatic cleaning of the heat exchanger.
-> risk of suffocation.
Has the condensation container been properly reinserted? – The heat exchanger contains coolant -> Dispose of it in the proper manner.
-> slide the condensation container in fully. – All materials are environmentally sound and can be reused. Dispose of in an
environmentally-responsible manner.
10
Observe the safety
instructions on page 11.
Tumble dryer
Instructions en
for installation and use
Read these instructions
11
before operating the dryer.