Drying; Cleaning The Fluff Filter; Removing The Laundry - Siemens WT46W570 Installation And Use Manual

specting the
dryer
nnecting the
mains plug
oading laundry
he programme
1
drying programme ...
2
idual requirements
e overview -> Page 7
e sensitive and only
uched lightly.
3
he Start/Stop button
the dryer with
inserted!
cs that require a
polyamide, elastane or
creasing phase once
vailable.
ng/ready.

Drying

Condensation container
with filter
Control panel
Drum interior light
Air inlet
Fluff filter
Drum
Drying
Do not pull out/empty the condensation container
when drying is in progress!
Emptying condensation
Empty container after each drying operation, and not when drying is in
progress!
1. Pull out condensation container keeping it horizontal.
2. Pour out condensation.
3. Always push container in fully until it clicks into place.
If flashes in the display panel -> Page 6/10.

Cleaning the fluff filter

Clean the fluff filter after each drying operation.
1. Open the door, then pull out and fold open the fluff filter.
2. Remove the fluff (by wiping the filter with your hand).
If the fluff filter is very dirty or blocked, rinse with warm water and dry
thoroughly.
3. Close and reinsert the fluff filter.
4. Remove fluff from door/door area.
Switching off the dryer
Turn the programme selector to Ο stop (Off).
Do not leave laundry in the dryer.

Removing the laundry

Your dryer is equipped with an automatic anti-crease function. The drum is moved at specific time intervals
for 30 minutes once the programme has ended. The laundry stays loose and fluffy (60 or 120 minutes if
the additional menos (Easy iron) function is selected).
The programme has ended
Interrupt programme
to load/unload laundry.
The drying operation can be interrupted briefly to load or unload laundry. The programme selected
must then be resumed and completed.
Never switch the dryer off before
the drying process has ended.
1. Open door, the drying process is interrupted.
2. Load or remove laundry and close door.
3. If required, select a new programme and additional functions.
4. Press the inicio/stop (Start/Stop) button.
3
when lights up in the display panel.
4