Logging In Using The Default Ip Address - NETGEAR WAG102 Reference Manual

802.11a/g prosafe dual band wireless access point

Hide thumbs Also See for WAG102:

Table of Contents

ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)

Logging In Using the Default IP Address

After you install the WAG102, log in to the wireless access point to configure the basic settings

and the wireless settings. The WAG102 is set, by default, with the IP address of 192.168.0.232

with DHCP disabled.

Note: The computer you are using to connect to the WAG102 should be configured with

an IP address that starts with 192.168.0.x and a Subnet Mask of 255.255.255.0.

To log in using the default IP Address:

1. Open a Web browser such as Mozilla Firefox, Internet Explorer or Netscape Navigator.

2. Connect to the WAG102 by entering its default address of http://192.168.0.232 into your

browser.

3. The login screen will display. Enter admin for the user name and password for the password,

both in lower case letters.

Figure 2-7

4. Click OK.

Your Web browser should automatically find the WAG102 Wireless Access Point and display

the home screen, as shown in

Basic Installation and Configuration

Figure 2-3 on page

2-6.

v2.0, September 2006

2-11

Table of Contents