Configuring Wpa With Radius - NETGEAR WAG102 Reference Manual

ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)
Note: If you use a wireless computer to configure WEP settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match
the new settings or access the wireless access point from a wired computer to
make any further changes.

Configuring WPA with RADIUS

Not all wireless adapters support WPA. Furthermore, client software is required on the client.
Windows XP and Windows 2000 with Service Pack 3 or above do include the client software that
supports WPA. Nevertheless, the wireless adapter hardware and driver must also support WPA.
Consult the product document for your wireless adapter and WPA client software for instructions
on configuring WPA settings.
To configure WPA, follow these steps:
1. Under Security on the menu, select RADIUS Server Settings. The RADIUS Server Settings
screen will display.
2. Enter the RADIUS Server Settings as shown in
page 2-25.
3. Click Apply to save your RADIUS Server settings.
4. Under Security on the main menu, select either Security Profile Settings 11a or Security
Profile Settings 11b/g. When the security profile screen displays, check the radio button of the
security profile you want to modify and click Edit.
Figure 2-16
Basic Installation and Configuration
"Configuring the RADIUS Server Settings" on
v2.0, September 2006
2-31