Basic Engine Parts; Installation 7 - O.S. engine MAX-32SX-H Series Owner's Instruction Manual

BASIC ENGINE PARTS

Glowplug
Carburetor
Typr 20C
Beam Mount
Needle valve
Propeller nut
Crankshaft
Heatsink Head
Crankcase
Recoil Starter
Assembly No.O
Starter Handle
MAX-32SX-HX
7
INSTALLING THE GLOWPLUG
Install washer on glowplug
and insert carefully into
cylinder-head, making sure
that it is not cross-threaded
before tightening firmly.
INSTALLATION
The under-surfaces of all O.S. engine beam
mounting lugs are precision machined flat and
exactyly parallel to the engine's horizontal axis. It is
essential that the engine mounts in the model are
also accurately made and aligned. If they are not,
they will cause stress and distortion within the engine
itself, probably resulting in loss of performance and
internal damage.
The recommended screws for securing the engine to
the engine mounts in the model are 3mm or 4-40
steel Allen type. It is also advisable to use lock
washers or LOCTITE to prevent nuts from loosening.
Glow plug
Washer