Match PP 41DSP User Manual page 16

Fig. 3 Connection of the amplifier to the car radio
This male connector will be plugged into the vehicle harness that has been discon-
1
nected from the car radio.
The female connector will be plugged into the car radio.
2
The 20-pole connector will be plugged into the MATCH PP 41DSP amplifier.
3
Fig. 4 Possibility for direct power supply from the battery
This side of the cable harness will be directly connected to the car's battery. Therefore
4
you have to separate the cable joints I and H.
After separating the joints I and H the unused open wire ends have to be properly
5
insulated with tape or other appropriate material.
The +12 volts wire has to be connected to the positive terminal of the car's battery
I
The ground wire has either to be connected to the negative terminal of the battery or
H
directly to the car's chassis
18
3
4
2
1
I
5
H