Match PP 41DSP User Manual page 14

Selection of a sound setup
The PP 41DSP has an internal memory for a ma-
ximum of 16 different sound setups. On the side
panel of the amp you will find two push buttons
that are used to select one of these. The ▲-push
button increments the setup number whereas the
▼-push button decrements the setup number.
The 2-digit LED display on the top side indicates
the chosen setup. In normal operation this display
simply shows "41", but as soon as one of the two
push buttons is pressed for less than one second,
the display indicates the currently active DSP
setup. Make your setup choice by keeping one of
the two push button pressed for more than one
second. Each number in the display stands for
Display
Displaying the selected sound setup
Selecting a sound setup
16
Simply press one of the two push but-
tons for less than one second and the
currently selected DSP setup will be
displayed.
If you want to select a different DSP
setup you first have to press one of
the two push buttons for at least one
second.
Then select the right setup for your
car until the appropriate number is in-
dicated on the 2-digit LED display. A
list of the available DSP setups can be
found on the backside of the amplifier
or its gift box.
After a couple of seconds the LED
display will switch back to „41" and
the setup process is finished. Now the
amplifier is properly programmed for
your car.
a sound setup. A list of all stored setups can be
either found on the bottom plate of the amplifier or
on the backside of the gift box. If less than 16 se-
tups are stored, empty memory slots will be auto-
matically skipped.
Note: The amplifier has to be switched on for se-
lecting a setup. The setup won't be lost if you turn
the device off or even separate it from the power
supply.
...