Router Front Panel - NETGEAR MR814 802.11b Cable/DSL Wireless Router MR814 MR814 Setup Manual

Router Front Panel

Figure 2
You can use the status lights on the front of the wireless router to verify various conditions.
Table 1-1. Status Light Descriptions
Item Function Activity
Power On green solid
1
Off
Test On
Off
2
Slow blinking
Wireless On
Off
3
Blinking
Internet Amber off
Amber on
Amber blinking
4
Green off
On
Blinking
LAN Green
5
Amber
Getting to Know Your Wireless Router
Description
Power is supplied to the router.
Power is not supplied to the router.
The unit is performing the power-on self-test diagnostic.
The unit successfully completed the power-on self-test diagnostic.
The reset button is being pushed, restoring the factory default
settings.
The wireless interface is enabled.
The wireless interface is turned off.
Data is being communicated over the wireless network.
No Ethernet cable is connected to the modem.
The Ethernet cable connection to the modem is good.
Packets are being transmitted and received from a modem or other
network device, but no IP address has been received.
No IP address has been received.
IP address has been received.
IP address received and data is being transmitted and received.
The LAN port has detected a 100 Mbps link with an attached device.
The LAN port has detected a 10 Mbps link with an attached device.
v1.0, August 2007
Wireless Router Setup Manual
3