Accessing The Wireless Router After Installation And Checking For New Firmware - NETGEAR MR814 802.11b Cable/DSL Wireless Router MR814 MR814 Setup Manual

Documentation link under Web Support to view support information or the documentation for the
wireless router.
Accessing the Wireless Router after Installation and
Checking for New Firmware
The Smart Wizard appears only when you first install the router or when the router is in its factory
default state (for example, if you have reset the router to its factory default settings). If you want to
change the settings after installing and configuring your router using the Smart Wizard, you must
open a browser window and log in to the router.
The factory default state is restored when you use the factory reset button. See
Do I Restore the Default Password and Configuration Settings?" on page 24
information about this feature.
To access the router using its login name and password:
1. Connect to the wireless router by typing http://www.routerlogin.net in the address field of
your browser, and then click Enter.
Figure 13
You can connect to the wireless router by typing any one of these three URLs in the
address field of your browser, then clicking Enter:
http://www.routerlogin.net
•
http://www.routerlogin.com
•
• http://192.168.1.1
2. For security reasons, the router has its own user name and password. When prompted, enter
admin for the router user name and password for the router password, both in lower case
letters.
The router user name and password should not be confused with any user name or
password you may use to log in to your Internet connection.
Getting to Know Your Wireless Router
v1.0, August 2007
Wireless Router Setup Manual
"How
for more
13