Router Front Panel - NETGEAR FVS124G Reference Manual

FVS124G ProSafe VPN Firewall 25 Reference Manual

Router Front Panel

The ProSafe VPN Firewall 25 with 4 Gigabit LAN and Dual WAN Ports front panel shown below
in Figure 1-1 contains the port connections, status LEDs, and the factory defaults reset button.
Power
Test
LED
LED
Figure 1-1
The activity status of the router is shown by the LEDs on the
item on the front panel of the firewall and its operation.
Table 1-1. FVS124G front panel
Object Activity
PWR LED On (Green)
Off
TEST LED On (Amber)
Blinking (Amber)
Off
WAN Port Link/Act LED
LEDs On (Green)
Blinking (Green)
Off
100 LED
On (Green)
Off
Active LED
On (Green)
On (Amber)
Off
1-6
WAN1 Port
WAN2 Port
LEDs
LEDs
Description
Power is supplied to the firewall.
Power is not supplied to the firewall.
Test mode: The system is initializing or the initialization has failed.
Writing to Flash memory (during upgrading or resetting to defaults).
The system has booted successfully.
The WAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the WAN port.
The WAN port has no link.
The WAN port is operating at 100 Mbps.
The WAN port is operating at 10 Mbps.
The WAN port has a valid Internet connection.
The Internet connection is down or not being used.
The WAN port is either not enabled or has no link.
v1.0, January 2007
Gigabit LAN Port LEDs
router.Table 1-1 below describes each