5
Initial use
Setup
Remove the unit from the packaging.
Place it on a flat surface.
Ensure that the ventilation slits are free.
Push the lid [2] backwards to access the
accessory parts.
Before using the unit for the first time
Note:
• Before you use the unit for the first
time, clean it thoroughly. The same
applies if you haven't used the device
for a prolonged period. See "Cleaning
and maintenance" on page 28.
• Attach the hose [8] at the bottom of
the atomizer [9].
• Connect the other end of the hose [8]
to the hose connector [6] on the com-
pressor by lightly turning it.
Mains connection
Connect the unit only to the mains volt-
age listed on the type plate.
• Insert the mains cable plug [1] into a
suitable socket.
• Push the plug completely into the
mains socket.
Note:
• Ensure that there is a socket near to
where the unit will stand.
• Lay the mains cable in such a way
that no one can trip over it.
• To disconnect the compressor from
the mains after use, first switch off the
device and then remove the plug from
the socket.
23