Oregon Scientific wd338 User Manual page 44

Multi-handset use
"I'm having problems registering a new handset."
* Unplug and plug in again the mains power cord of the base unit to activate the
registration procedure.
* Make sure you have selected a base number that is not already assigned, and
ensure you choose from the base numbers that are not flashing.
* The base unit may have already registered all 5 handsets. You need to de-
register (delete) one of them before registering a new handset.
* If you are replacing a faulty handset, make sure you have de-registered the
faulty one before registering the new one.
"I cannot make a call."
* Only one outside call and one intercom call can take place at once. Make sure
no other handset user is already on a call.
* Please check if another handset has engaged the line already. If this is the case
you will see "EXT" on your handset. When you press
engaged tone.
Advanced telephone features
Problems with programming
" I changed the PIN, and I've forgotten the new one."
* Please refer to section 6 Resetting your system.
Weather station features
" I cannot register my sensor with the base unit. "
* Select channel by pressing [CHANNEL] on the base unit.
* Reset the sensor and place it close to the base unit. Wait 10-15 minutes to
ensure the sensor has enough time to connect to the base unit.
OR
* Press & hold the [CHANNEL] button for 2-3 seconds, to enable the base unit to
search for the sensor.
" I cannot set the clock and date. "
* Press and hold the [ALARM] button until you see "TIME" on the display of the
base unit flashing, then press [
, you will hear the
] or [ ] to amend.
44