Using The Lens Antitheft Screw - Sanyo PLC-WTC500AL Service Manual

Maintenance

Using the Lens Antitheft screw

This projector provides a Lens antitheft screw to protect the projection lens stolen from a suspicious person.
Mount the Lens antitheft screw by following the instructions below.
Mounting the Lens antitheft screw
1
Loosen a screw-A on the lamp cover and slide it
backward, and then loosen a screw-B on the prism
cover and turn it up in the arrow direction (Fig. 1).
2
Insert the Lens antitheft screw onto the screw hole
on the cabinet top and turn it until the lens release
button is locked (Fig. 2).
3
Close the prism cover and tighten the screw-B, and
close the lamp cover and tighten the screw-A.
4
Check that the lens release button is locked to pro-
tect the projection lens removing.
Note: Be careful not to drop the Lens Antitheft screw
into the opening of the projector when mounting
the screw.
Lens Antitheft
screw
Prism cover
Lamp cover
A
-17-
B
Fig. 1
Fig. 2