Kobalt KL12120 Operating Instructions Manual page 6

OPERATING INSTRUCTIONS 120 VOLT AC MODE
CAUTION: DO NOT OVERINFLATE ITEM BEING INFLATED.

Place inflator evenly on flat surface.

Insert the 120 Volt AC Power Cord into a grounded 120 Volt AC Outlet and this will
automatically provide continuous 120 volt current to your inflator.

Connect the Quick Connect Valve Adaptor to item you are inflating and push down the
Valve Lock Lever to secure the connection.

Push the Power Selector Switch in the top left corner of the inflator to the 120 Volt,
position. (Please see Image #2 below).

The Digital Pressure Gauge will display the current pressure of the item you are inflating.
When the LCD readout screen is displaying the current PSI, the LCD readout is static.

Press the ▲ button on the Digital Pressure Gauge to set the desired PSI. The Digital
Pressure Gauge preset range is 3 PSI minimum to 120 PSI maximum. When the LCD
readout screen is displaying the target PSI, the LCD readout will blink 3 times at the
desired preset level and it will then change back to the current PSI level of the item you are
inflating.
Note: If the current pressure of the item you are inflating is greater than the preset level,
the inflator will not turn on.

To turn the inflator on, push the Run/Pause,
changed during inflation, simply press the ▲ or ▼buttons to new desired PSI level.

The inflator will shut off automatically at the desired preset PSI level that you have
programmed into the Digital Pressure Gauge.
Note: The inflator has a tolerance of + or – 2 PSI and will automatically shut off
accordingly.

To stop the inflator before it reaches the preset PSI level, push the Run/Pause button. To
resume inflation, simply press the Run/Pause button again.
Note: Disconnecting inflator from 120 Volt AC Outlet will clear the previous preset PSI setting.
Image #2
button. The preset PSI level can be
6