Safety Information; Product Specifications - Kobalt KL12120 Operating Instructions Manual

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the
product.
The safety instructions provided in this manual are not intended to cover all possible conditions that
may occur during product operation. Always use common sense and pay attention to all WARNING
and CAUTION statements in this manual.
Work Area: Keep your work area clean and well lit. Cluttered benches and dark areas increase
the possibility of personal injury or property damage
Do not operate power tools in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust.
Keep bystanders, children and visitors away while operating a power tool. Distractions can
cause you to lose control.

PRODUCT SPECIFICATIONS

CAUTION: THIS INFLATOR OPERATES ON DC 12 VOLT AND AC 120 VOLT. DO NOT
ATTEMPT TO OPERATE THIS INFLATOR WITH ANY OTHER SOURCE OR VOLTAGE. DO NOT
REWIRE OR RECONFIGURE INFLATOR FROM ITS ORIGINAL DESIGN OR PERSONAL INJURY
OR BODILY HARM MAY OCCUR.
Model
Voltage/Hertz/Phase/Current
Max Working Pressure
Voltage
Power Requirement
Max Working Pressure
Note: This unit is equipped with fuse protection. If at some point the inflator fails to
operate when using the 12 volt DC power method, check the fuse in the end of the 12 volt plug.
To replace the fuse, simply unscrew the 12 volt power plug tip, remove existing fuse, install new
fuse and reassemble power plug tip. Use only an AGC – 10 Amp replacement fuse.
KL12120
120/60/1/1.5A
120 PSI
DC 12 V
DC 12 V – For use with 12 Volt DC Power Outlet Only
120 PSI
3