Carrier 33AW-CS1 Installation Manual page 10

Installation
To Enter the Installer Configuration Mode
Press zone ( ) and hold ( ) buttons simultaneously
for 3 seconds, the parameter number will be flashing on
the timing-zone and parameter value will be displayed in
temperature-zone of the display.
Press mode (M) button, the parameter value will be flashing
in the temperature-zone of the display.
Press up or down buttons to change the value settings Press
the mode (M) button or OK button to freeze the settings.
Pressing OK button will save your settings and
parameter value will be flashing, you can change the
value further.
Pressing mode (M) button will save the settings and it
will enable the next parameter to be changed. The
parameter number will be flashing.
Pressing zone ( ) button will NOT save the settings
and normal display screen will be displayed.
Press up and down button to go to the next parameter once
completed, press OK button to save the settings and will
return to the normal display screen.
10
3 sec
By example, it is explained how to change the settings for
some of the parameters.
Refer the example for configuring all other parameters.
Parameter number (ref table 1)
Parameter value (ref table 1)