NetComm V24W User Manual page 39

2. Access the Router's Web-based Utility by going to http://192.168.1.1 or
3. A login screen will appear. Leave the User Name field blank. Enter the
4. Click the Applications & Gaming tab, and then click the Port Range
5. For each port range you must specify, enter a different name in the
6. Select the protocol you will be using, UDP.
7. Enter the IP address of the IP Phone. For example, if the IP Phone's IP
8. Repeat steps 5-7 until you have entered all four port ranges for the IP
Application
Enable Internet Phone 1
X Internet Phone 2
X Internet Phone 3
X Internet Phone 4
9. Check the Enable option for the port services you want to use.
10. When you have completed the configuration, click the Save Settings
4. The power LED does not light up.
Go through this checklist until your problem is solved:
•
Remove the IP Phone's battery from its compartment. Wait five seconds while the IP
Phone resets itself. Insert the battery and power on the IP Phone.
•
You may be using the wrong power adapter. Make sure the power adapter you are
using is the one included with the IP Phone.
YML873 V24W User Guide - 38
the IP address of the Router.
Router's password (the default is admin) in the Password field. Then
click the OK button.
Forwarding tab.
Application field. Then enter the number or range of external port(s) used
by the IP Phone.
address is 192.168.1.100, you would enter 100 in the field provided.
Phone.
Start and End
5060 to 5061
53 to 53
69 to 69
10000 to 20000
button.
NetComm VoIP WiFi Phone V24W User Guide
Protocol IP Address
UDP IP address of IP Phone
UDP IP address of IP Phone
UDP IP address of IP Phone
UDP IP address of IP Phone