Installation - Scantronic I-RK01 Installation Manual

Radio keypad
Table of Contents

Advertisement

Compliance
Statements
Preparation
Before installation you should carry out a radio survey of the site to
assess where to place the keypad so that the control unit can
receive signals from it successfully.
To do this you should conduct signal strength tests. Cooper
Security produces the Scantronic 790r hand held signal strength
meter for this purpose.
Siting the Keypad
Do site the keypad:
Within the area protected by the alarm system.
At a convenient height and location for the user.
Out of sight of potential intruders.
Do NOT site the keypad:
Outside the area covered by the alarm system.
Close to or on large metal structures.
Closer than one metre to mains wiring and metal water or gas
pipes.
Inside steel enclosures.
Next to electronic equipment, particularly computers,
photocopiers or other radio equipment, CAT 5 data lines or
industrial mains equipment.
Note that some window glasses, especially those sold as
"insulating" or "energy conserving" may be coated with thin metal
or conducting films. These glasses are particularly poor at
transmitting radio waves.
Fitting
Use M3 25mm roundhead screws in at least three fixing holes when
mounting the back of the keypad on the wall. (If using a UK back
box then two point fixing is sufficient.)
Page 4
This product is suitable for use in systems designed to comply with PD
6662: 2004.
Conforms to 1999/5/EC R&TTE directive. See declaration of conformity
at www2.coopersecurity.co.uk.

Installation

I-RK01

Advertisement

Table of Contents
loading

Table of Contents