Maintenance; Panic Alarm - Scantronic I-RK01 Installation Manual

Radio keypad
Table of Contents

Advertisement

Quick Set
If the user wishes to employ Quick Set then make sure that Installer
Menu - System Options - User Access - Quick Set is set to "Yes".
To Set the System

Panic Alarm

If the user needs the PA function then make sure that Installer Menu
- System Options - User Access - PA Keys active is set to "Yes"
To start a PA press both PA buttons at the same time (3 on Figure
1).
The radio keypad batteries typically last for two years. When the
batteries are low the control unit reports an alert with the text
"Radio Kpd Low Batt". The batteries should be replaced by an
installer.
Cleaning
Clean the outside of the case with a soft dry cloth. Do not use
water, solvents or any proprietary cleaning agents.
© Cooper Security Ltd. 2008
Every effort has been made to ensure that the contents of this book are correct. However,
neither the authors nor Cooper Security Limited accept any liability for loss or damage caused
or alleged to be caused directly or indirectly by this book. The contents of this book are subject
to change without notice.
Printed and published in the U.K.
This manual applies to software used in the I-ON16 control unit with version 1.xx.xx software.
www.coopersecurity.co.uk
Product Support (UK) Tel: +44 (0) 870 757 5400.
Available between:
08:15 and 17:00 Monday to Friday.
Product Support Fax: (01594) 545401
Part Number 11847978 Issue 1
Page 8
1.
Either Press A to Full Set
Or press B to Part Set.

Maintenance

I-RK01

Advertisement

Table of Contents
loading

Table of Contents