Table of Contents
Advertisement
Before fitting the front of the keypad to the back box you should
make the i-on control unit learn the keypad's identity. To do this
you must first enter the Installer Menu at a wired keypad.
To Add a Radio Keypad
1.
Select Detectors/Devices–Radio Keypads-Add/Del Radio Keypad.
The display lists the available Radio Keypads. Each line is a
"memory slot" for learning the identity of an individual Radio
Keypad.
If a memory slot is already occupied then the beginning of the line
shows a "*".
2.
Select the memory slot that you wish to use.
The display asks you to activate the tamper switch on the Radio
Keypad.
3.
Activate the Radio Keypad tamper.
The Radio Keypad signals its identity to the I-ON16 control unit.
When the control unit learns the Radio Keypad's identity it gives a
double beep.
To Delete a Radio Keypad
1.
Select Detectors/Devices–Radio Keypad-ADD/DEL Radio Keypad.
2.
Select the Radio Keypad that you wish to delete.
The display asks you to confirm that you wish to delete the selected
Radio Keypad.
3.
Press Y.
The control unit deletes the Radio Keypad's identity and gives a
double beep.
User Operation
LED A glows while the keypad is transmitting. The keypad ignores
any key presses while the LED is alight. (LED A does NOT indicate
the system status.)
The radio keypad does not provide any status information about the
alarm system. To read alerts or reset the system after an alarm the
Page 6
Programming
I-RK01
Advertisement
Table of Contents
