Page 2
I-RK01 Introduction The I-RK01 Radio Keypad is designed to work with the I-ON16 control unit. This unit allows you to set and unset an i-on alarm system remotely. Figure 1 shows the main controls and displays. 2 abc 3 def...
I-RK01 DD243 single Prox enable action unset Front housing (from the inside) Back box 1. Sound (key tones only) 2. Tamper switch 5. Jumpers 3. Batteries (3x AA alkaline) 6. Fixing screw holes 4. AC/DC IN 9V-12V 7. Break out for back tamper Figure 3.
To do this you should conduct signal strength tests. Cooper Security produces the Scantronic 790r hand held signal strength meter for this purpose. Siting the Keypad Do site the keypad: Within the area protected by the alarm system.
I-RK01 Figure 4. Screw Keypad Back Box to Wall Setting the Jumpers There are two jumpers (4 on figure 3) that affect the operation of the keypad: DD243 Single Fitted: the keypad transmits an unset action unset command two seconds after the user presents a recognised proximity tag.
I-RK01 Programming Before fitting the front of the keypad to the back box you should make the i-on control unit learn the keypad’s identity. To do this you must first enter the Installer Menu at a wired keypad. To Add a Radio Keypad Select Detectors/Devices–Radio Keypads-Add/Del Radio Keypad.
Page 7
I-RK01 user must go to a wired keypad and press Y as described in the User Guide. Setting/Unsetting With Access Code A user can always set and unset the system with a valid access code from the radio keypad. To Set the System Key in a valid access code.
I-RK01 Quick Set If the user wishes to employ Quick Set then make sure that Installer Menu - System Options - User Access - Quick Set is set to “Yes”. To Set the System Either Press A to Full Set Or press B to Part Set.