Table of Contents
Advertisement
I-RK01
user must go to a wired keypad and press Y as described in the
User Guide.
Setting/Unsetting With Access Code
A user can always set and unset the system with a valid access
code from the radio keypad.
To Set the System
To Unset the System
Silencing an Alarm
Setting/Unsetting With Proximity Tag
If the user wishes to set and unset the system using an proximity
tag then make sure that you have fitted the prox enable jumper
(see figure 3). The admin user will also have to make the system
learn the identity of a proximity tag and assign it to a user.
To Set the System
To Unset the System
Silencing an Alarm
1.
Key in a valid access code.
2.
Either Press A to Full Set
Or press B to Part Set.
(If you wish to stop setting while the
exit tone sounds, then press
1.
Key in a valid access code.
2.
Press
.
1.
Key in a valid access code.
2.
Press
.
1.
Momentarily hold the tag up against
the proximity tag sensor (1 in figure
1). The keypad glows blue and
gives a "click" to show that it has
recognised the tag.
2.
Either Press A to Full Set
Or press B to Part Set.
1.
Momentarily hold the tag up against
the proximity tag sensor. The
keypad glows blue and gives a
"click" to show that it has
recognised the tag.
2.
Press
.
1.
Hold the tag up against the
proximity tag sensor.
2.
Press
.
.)
Page 7
Advertisement
Table of Contents
