Network Settings - Sony bravia klv-40x450a Operating Instruction

Network Settings

Network
Server Display
Settings
Server Diagnostics
Renderer Function
Renderer Access
Control
Renderer Set-up
42
GB
Audio Filter Improves the sound of individual channels when distortion
occurs in mono broadcasts. Sometimes a non-standard
broadcast signal can cause sound distortion or intermittent
sound muting in mono programmes.
If you do not experience any sound distortion, we recommend
that you leave this option to "Off" (factory setting).
~
• You cannot receive stereo or dual sound when "Low" or
"High" is selected.
Skip Skips unused channels when you press PROG +/– to select
channels. To select channels you have programmed to skip,
use the corresponding number buttons.
Signal Booster
Improves the picture quality if the TV signal is too strong or
(Intelligent weak.
Signal Booster) If the signal is too strong (picture distorted; picture with lines;
signal interference), set to "Off". If the signal is weak (snowy
picture), set to "Auto".
Colour System Selects the colour system ("Auto", "PAL", "SECAM",
"NTSC3.58", "NTSC4.43") according to the channel.
Signal Level Displays the signal level for programme currently being
watched.
IP Address DHCP
Settings
Manual
Test
Diagnoses whether the network is correctly connected.
IP Address/
You need to configure each item when "Manual" is selected
Subnet Mask/ in "IP Address Settings".
Default Gateway
MAC Address Displays the MAC address, which is a fixed, globally unique
identifier of the network device.
Displays the connected server list and allows you to select the server you want to
display on the Home Menu.
Diagnoses whether the TV can connect to each server on the home network.
Enables playback of photos or music on the TV through other control devices on
the network, such as a digital still camera or mobile phone.
Allows you to specify the accessible controller to the TV. When this setting is set to
"On", you can playback photos or music on the TV using the controller.
Automatic
Allows you to select whether to permit access to the TV
Access automatically when a network device accesses the TV for the
Permission first time.
Renderer Name Allows you to set the name of the TV to be shown on the
controller.
Automatically acquires the network
settings through the Dynamic Host
Configuration Protocol server function of
the router or Internet service provider.
Allows you to set the network settings
according to your network environment.