Table of Contents
Advertisement
3
Connect the jumper cables according to the following procedure:
1
Connect a positive jumper cable clamp to the positive (+) battery
terminal on your vehicle.
2
Connect the clamp on the other end of the positive cable to the
positive (+) battery terminal on the second vehicle.
3
Connect a negative cable clamp to the negative (-) battery termi-
nal on the second vehicle.
4
Connect the clamp at the other end of the negative cable to a
solid, stationary, unpainted metallic point away from the battery
and any moving parts, as shown in the illustration.
4
Start the engine of the second vehicle. Increase the engine speed
slightly and maintain at that level for approximately 5 minutes to
recharge the battery of your vehicle.
5
Vehicles with a smart key system only: Open and close any of the
doors of your vehicle with the engine switch off.
6
Maintain the engine speed of the second vehicle and start the
engine of your vehicle by turning the engine switch to the "ON"
position (vehicles without a smart key system) or turning the engine
switch to IGNITION ON mode (vehicles with a smart key system).
7
Once the vehicle's engine has started, remove the jumper cables in
the exact reverse order from which they were connected.
Once the engine starts, have the vehicle inspected at your Toyota
dealer as soon as possible.
4RUNNER (U)_(OM35B23U)
7-2. Steps to take in an emergency
I n f o r ma t i o n P r o v i d e d b y :
449
7
Advertisement
Table of Contents
