D-Link DES-1228 Manual page 57

5 Configuration
The steps of adding an access profile is like below:
1) After selecting the Profile ID and Frame Type (MAC or IPv4), specify attributes like Untagged/Tagged (for
MAC), or ICMP/IGMP/TCP/UDP (for IPv4), then click Select and a simplified frame diagram will be displayed.
2) Select the field of interest and related columns will be displayed in lower part of the page. Enter the
filtering mask and click Create when done. A filtering mask is to specify the digit that you want to check. For
example, if you want to check a network of 192.168.1.0/24, then you should enter the IP mask as
255.255.255.0.
3) After the Profile ID has been created, it will go back to the main Access Profile List page, clicking the Edit
/ New Rules button to enter Access Rule List page.
Profile ID: Indicates the corresponding access profile Identification number.
Access ID: Indicates the access rule Identification number.
Profile Type: Displays the profile type.
Figure 85 – Add Access Profile
NOTE: You cannot select Payload in a MAC ACL,
or L2 Header in IP ACL.
Figure 86 – Access Rule List
5 5 3 3
D-Link Web Smart Switch User Manual